Test Ch-VER, Verification Procedure
WARNING: This page is about a different car, the 1994 Eagle Vision, 1994 Dodge Intrepid, 1994 Chrysler New Yorker, 1994 Chrysler LHS, and 1994 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.
- Inspect and ensure that all engine components are connected. If other trouble code(s) was previously present and has not yet been corrected, see TEST TC-1A, CHECKING SYSTEM FOR TROUBLE CODES . If Powertrain Control Module (PCM) has been changed and vehicle is equipped with Vehicle Theft Security System (VTSS), turn ignition on then off at least 20 times to activate VTSS. If PCM has not been changed, using DRB, erase trouble codes. Using DRB, reset all values in adaptive memory and disconnect DRB.
- Ensure no other charging system problems remain by doing the following:
- Turn on A/C and blower motor (if equipped with A/C).
- Drive vehicle for no less than 5 minutes and attain a speed of 40 MPH.
- Ensure transmission shifts through all gears.
- After completion of road test, turn engine off.
- Start engine and idle for no less than 2 minutes.
- Turn engine off.
- Connect DRB to DLC and read trouble codes.
- If previously repaired trouble code has reset, repair is incomplete. Check all related TECHNICAL SERVICE BULLETINS and return to TEST TC-1A, CHECKING SYSTEM FOR TROUBLE CODES if needed. If other codes are present, see TEST TC-1A, CHECKING SYSTEM FOR TROUBLE CODES . If there are no other trouble codes, repair is complete.