Test 1B - Testing System Function

WARNING: This page is about a different car, the 1995 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: For connector terminal identification, see Figure .

NOTE: Perform TEST 1A before proceeding.

Ensure ignition is off. Using key, turn left door lock to UNLOCK position. Turn ignition on. Using DRB, read VTA status. If DRB displays CURRENT MODE DISARMED, system is functioning properly. Perform TEST VER-1A . If DRB does not display CURRENT MODE DISARMED, replace VTA module. Perform TEST VER-1A .