Test 18B - Repairing Disarm Sense Circuit From (RKE)

WARNING: This page is about a different car, the 1995 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: For connector terminal identification, see Figure .

NOTE: Perform TEST 18A before proceeding.

Ensure all courtesy, dome and cargo lights are functioning properly. Repair interior lights as necessary. If lights are functioning properly, go to next step.
Turn ignition off. Disconnect Remote Keyless Entry (RKE) module. See Figure in TEST 3A. Using DRB in voltmeter mode, check voltage at RKE module connector terminal No. 7 (Violet/Yellow wire). If voltage is less than 10 volts, repair open in Violet/Yellow wire. Perform TEST VER-1A . If voltage is more than 10 volts, replace RKE module. Perform TEST VER-1A .