Installation (5 Passenger Models)
WARNING: This page is about a different car, the 1994 Eagle Vision, 1994 Dodge Intrepid, 1994 Chrysler New Yorker, 1994 Chrysler LHS, and 1994 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.
- Fold carpeting back into position on left floor pan of vehicle. Install throttle pedal and bracket back on dash panel studs and install attaching nuts.
- Install rear passenger compartment heat duct back into vehicle. Install rear console assembly mounting bracket on the park brake cable reaction bracket. Torque rear console assembly mounting bracket to reaction bracket mounting bolts to 88 INCH lbs. (10 N.m).
- Install drivers side cowl kick molding. Install drivers side door opening sill molding.
- Install upper center console cover assembly back in vehicle.
- Install shift knob on floor shifter (if equipped). Shift knob is installed by pushing shift knob down shift shaft until fully bottomed. Then install and tighten 3/32 INCH Allen head set screw located on drivers side of shift knob.
- Disconnect negative battery cable. Remove adjuster attaching bolts and nuts from floor pan. Move seat position adjuster for access. Disconnect wiring harness at carpet. Remove seat assembly.
- When repairs are complete, adjust rear brakes before adjusting parking brake. See Parking Brake Adjusting Procedure . On drum-in-hat type of rear disc brake adjust shoe diameter to 6.75 INCH (171.5 mm).