Left & Right Impact Sensors: Installation
WARNING: This page is about a different car, the 1995 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- Mount sensor with arrow pointing toward front of vehicle. Install NEW screws and tighten to 35-45 INCH LBs. (4-5 N.m). Use only screws supplied with new sensor.
- Connect sensor electrical connector, ensuring locking tab is engaged. To complete installation, reverse removal procedure. DO NOT connect negative battery cable at this time. Perform system operation check to ensure system is functioning properly. See TESTING - SYSTEM OPERATION CHECK .