LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1996 >> Grand Cherokee Limited, 5.2 Y >> Repair and Diagnosis >> External Pages >> Different car >> Section 178 (5.2L V8 Gas - VIN [Y]) >> Removal & Installation >> Oil Pan >> Installation (Dakota 4WD)

Installation (Dakota 4WD)

WARNING: This page is about a different car, the 1995 Jeep Grand Cherokee, 1995 Dodge Ram Wagon, 1995 Dodge Ram Van, 1995 Dodge Pickup, and 1995 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. To install, reverse removal procedure. Before installing oil pan, apply RTV sealant where front cover contacts cylinder block, oil pan side gaskets meet end seals and end seals contact cylinder block. See Figure.
  2. When installing front drive axle, loosely install all bolts before tightening to specification. Tighten axle shaft nut to specification with vehicle on ground. See TORQUE SPECIFICATIONS . Ensure reference marks on transfer case yoke and front drive shaft are aligned.
scientia non olet · About LEMON Manuals