LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1996 >> Grand Cherokee Limited, 5.2 Y >> Repair and Diagnosis >> External Pages >> Different car >> Section 178 (5.2L V8 Gas - VIN [Y]) >> Removal & Installation >> Intake Manifold >> Installation

Intake Manifold: Installation

WARNING: This page is about a different car, the 1995 Jeep Grand Cherokee, 1995 Dodge Ram Wagon, 1995 Dodge Ram Van, 1995 Dodge Pickup, and 1995 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install plenum pan and install all bolts finger tight. Tighten bolts to specification, in steps, and in sequence. See Figure. See TORQUE SPECIFICATIONS .
  2. Install manifold flange gaskets on cylinder head with "MANIFOLD SIDE" words visible. Place a 13/64" (5 mm) bead of silicone rubber adhesive sealant at 4 corner joints. Install front and rear gaskets. Ensure holes in front and rear gaskets engage with dowels in cylinder block.
  3. Install intake manifold and install all bolts finger tight. See Fig 1. Tighten bolts to specification, in steps, and in sequence. See TORQUE SPECIFICATIONS . To install remaining components, reverse removal procedure.
Fig 1: Intake Manifold Bolt Tightening Sequence
G92J21682Courtesy of CHRYSLER CORP.
scientia non olet · About LEMON Manuals