LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1996 >> Cherokee Classic, Part Time, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 71 (CRUISE CONTROL SYSTEMS - 95 Cirrus & Stratus (VIN X), 96 Breeze, Cirrus & Stratus) >> Self-Diagnostics Tests >> Test TC-35C - No Vehicle Speed Sensor Signal

Test TC-35C - No Vehicle Speed Sensor Signal

WARNING: This page is about a different car, the 1996 Plymouth Breeze, 1996 Dodge Stratus, 1996 Chrysler Cirrus, 1995 Dodge Stratus, and 1995 Chrysler Cirrus. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition off. Using scan tool in ohmmeter mode, check resistance on VSS connector ground circuit Black/Light Blue wire. If resistance is less than 5 ohms, go to next step. If resistance is 5 ohms or more, repair open VSS ground circuit. Perform TEST VSS-VER - ROAD TEST VERIFICATION .
  2. Disconnect Powertrain Control Module (PCM) connector. Inspect PCM connector for pushed out or damaged terminals. Repair PCM connector as necessary. Perform TEST VSS-VER - ROAD TEST VERIFICATION . If PCM connector is okay, replace PCM. Perform TEST VSS-VER - ROAD TEST VERIFICATION .
scientia non olet · About LEMON Manuals