LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2021 >> XF S >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Engine - V6 S/C 3.0L Petrol -- XE (X760)) >> Engine - V6 S/C 3.0L Petrol >> Crankshaft Front Seal >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
  1. CAUTION:
    • Do not over tighten the crankshaft front seal. Failure to follow this instruction may result in damage to the vehicle.
    • Take extra care not to damage the seal.

    Using the special tool install the front crankshaft oil seal.

    Special Tool(s):  303-1434

    Renew Part:  Crankshaft front oil seal.

  2. Install the crankshaft pulley.

    Refer to: Crankshaft Pulley - Installation .

  3. Connect the startup battery ground cable.

    Refer to: Battery Disconnect and Connect (General Procedures).

scientia non olet · About LEMON Manuals