DTC P2047-13: Reductant Injection Valve Circuit/Open Bank 1 Unit 1 - Circuit open: Action

WARNING: This page is about a different car, the 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: A fault clear is NOT sufficient to clear the vehicle 'inducement' system warnings. The 'inducement' warnings automatically clear ONLY upon confirmation of the repair by the vehicle OBD system. The monitoring MUST be completed. The electrical checks normally occur when ignition is on or after engine start

Prioritized Checks to Perform
- Refer to the electrical circuit diagrams and check the diesel exhaust fluid injector circuit for open circuit, high resistance
- Inspect connectors for signs of water ingress, and pins for damage and/or corrosion
- Install a new diesel exhaust fluid injector, only when diagnosed as failed
Vehicle Conditions to Enable DTC Logging Strategy
- Engine running
- On completion of the previous repair actions the following MUST be completed
- Using the Jaguar Land Rover approved diagnostic equipment, clear the Diagnostic Trouble Code(s) and retest
- NOTE: The engine MIL is OFF (when engine ON)
- Start engine
- The 'inducement' warning clears automatically when the monitoring has completed and passed with no malfunction. This terminates the drive cycle
- NOTE: If the engine MIL shows during the driving cycle, then the malfunction has re-occurred. Further repair is required
- Using the Jaguar Land Rover approved diagnostic equipment, clear the Diagnostic Trouble Code(s)
- NOTE: This clears the fault storage from P2BAE/P2BAF