LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2019 >> XF S >> Repair and Diagnosis >> External Pages >> Different car >> Section 282 (Speed Control -- XE/(760)) >> Speed Control (G1817310) >> Removal And Installation >> Speed Control Switch - INGENIUM I4 2.0L Petrol (G1899121) >> Installation

Speed Control Switch - INGENIUM I4 2.0L Petrol (G1899121): Installation

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
    • Install the speed control switch.
    • Install the retaining screw.
    • Connect the electrical connector.
  2. NOTE: Make sure that the harness is routed to the position noted on removal.
    • Connect the electrical connector.
    • Install the paddle shifter.
    • Install the retaining screw.
  3. Install the driver airbag.

    Refer to: DRIVER AIRBAG MODULE

  4. Connect the startup battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT

scientia non olet · About LEMON Manuals