LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2019 >> XF S >> Repair and Diagnosis >> External Pages >> Different car >> Section 272 (Steering Column -- XE/(760)) >> Steering Column (G1817735) >> Diagnosis And Testing >> Heated Steering Wheel (G2878709) >> Pinpoint Tests >> Pinpoint Test J: Heated Steering Wheel High Current Check

Pinpoint Test J: Heated Steering Wheel High Current Check

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
  1. J1: HEATED STEERING WHEEL HIGH CURRENT CHECK 
    1. Remove the driver airbag module. Refer to: DRIVER AIRBAG MODULE
    2. Disconnect Steering wheel high current inline heated steering wheel electrical connector.
    3. Measure the resistance between the steering wheel high current inline heated steering wheel electrical connector (heater element side - high current power) and high current ground.
      G13894066Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Is the resistance 0 ohms or greater than 5 ohms? 

    Yes 

    Install a new steering wheel Refer to: STEERING WHEEL  TEST the system for normal operation.

    No 

    Install a new heated steering wheel control module or steering wheel switch assembly (depending on model variant) as necessary. TEST the system for normal operation.

scientia non olet · About LEMON Manuals