DTC U0415-02: Invalid Data Received From Anti-Lock Brake System (ABS) Control Module - General signal failure: Action
WARNING: This page is about a different car, the 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The FlexRay wiring harness must not be repaired by making a localised wiring repair. A new wiring harness should be installed.
- Refer to the electrical circuit diagrams and check the anti-lock brake system control module power and ground circuits for open circuit, high resistance. Repair the wiring harness as necessary
- Refer to the electrical circuit diagrams and check the FlexRay bus circuit for short circuit to ground, short circuit to power, open circuit, high resistance. Repair the wiring harness as necessary
- Using the Jaguar Land Rover approved diagnostic equipment, check the antilock brake system control module for related DTCs and refer to the relevant DTC index