Differential Vehicles With Heavy Duty Differential - INGENIUM I4 2.0L Petrol/V6 S/C 3.0L Petrol (G2131353): Removal

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Be prepared to collect escaping oil.

NOTE:

This procedure contains some variation in the illustration depending on the vehicle specification, but essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

Remove the engine cover.
Refer to: ENGINE COVER - INGENIUM I4 2.0L PETROL

Refer to: ENGINE COVER - INGENIUM I4 2.0L DIESEL

Refer to: ENGINE COVER - V6 S/C 3.0L PETROL
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Release the Emergency Park Release (EPR).
Raise and support the vehicle on a suitable 2 post lift.
Refer to: LIFTING

General Equipment: 2 post lift
Drain the rear differential oil.
Refer to: DIFFERENTIAL DRAINING AND FILLING VEHICLES WITH HEAVY DUTY DIFFERENTIAL
Remove the exhaust system.
Refer to: EXHAUST SYSTEM - INGENIUM I4 2.0L Petrol

Refer to: EXHAUST SYSTEM - INGENIUM I4 2.0L Diesel

Refer to: EXHAUST SYSTEM - VEHICLES WITHOUT: DIESEL EXHAUST FLUID - TDV6 3.0L Diesel

Refer to: EXHAUST SYSTEM - VEHICLES WITH: DIESEL EXHAUST FLUID - TDV6 3.0L Diesel

Refer to: EXHAUST SYSTEM- V6 S/C 3.0L Petrol
Remove both the rear halfshafts.
Refer to: REAR HALFSHAFT
NOTE: If equipped.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Disconnect the oil temperature sensor.
NOTE: If equipped.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Disconnect the breather tube and locking motor electrical connector.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Mark the position of the driveshaft in relation to the differential drive flange.
- Remove and discard the 6 driveshaft to differential drive flange bolts.
CAUTION: Make sure the tool is correctly installed in the groove on the driveshaft.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Install the special tool and release the driveshaft from the rear differential drive flange.

Special Tool(s): 205-932
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the vibration damper.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Position a suitable support below the differential case.
- Remove the 2 rear differential case mounting bolts.
General Equipment: Transmission jack
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the 2 front differential case mounting bolts and remove the differential case.
NOTE: If equipped.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Discard the breather.