Rear Silencer (G2142882): Removal

WARNING: This page is about a different car, the 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Observe due care when working near a hot exhaust system.

NOTE:

Removal steps in this procedure may contain installation details.
Right illustration shown, left is similar
Some variation in the illustrations may occur, but the essential information is always correct.
Some components shown removed for clarity.

Raise and support the vehicle on a suitable 2 post lift.
Refer to: LIFTING
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the exhaust mounting.

Torque : 55Nm
CAUTION: Make sure that a new bolt is installed.
NOTE:
- Do not disassemble further if the component is removed for access only.
- If equipped.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the exhaust Noise Vibration and Harshness (NVH) mass damper.

Torque : 22Nm