Exhaust System - Vehicles With: Diesel Exhaust Fluid: Installation

WARNING: This page is about a different car, the 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Steps 1-4 are only required if the components have been previously removed.
- Install the 2 rear NVH dampers.
- Install and tighten the 2 bolts.
  Torque : 22Nm
- Install the front NVH damper.
- Install and tighten the bolt.
  Torque : 22Nm
Use a suitable tool to install and tighten the post SCR particulate matter sensor.
Torque : 48Nm
Use the special tool to install and tighten the post SCR NOx sensor.
Special Tool(s): JLR-303-1666

Torque : 60Nm
WARNING: This step requires the aid of another technician.
- Install the exhaust system.
- Install the 2 exhaust mounting rubbers.
Install the exhaust rear silencer to the 2 mounting rubbers.
- Install a new gasket.
  Renew Part: Right exhaust downpipe to DPF gasket Quantity: 1 .
- Install the exhaust system to the DPF .
- Install and tighten the 2 nuts.
  Torque : 40Nm
CAUTION: Make sure that the area around the component is clean and free of foreign material.
- Install a new DEF injector clamp.
  Renew Part: Diesel exhaust fluid injector clamp kit Quantity: 1 .
- Install the DEF injector.
- Tighten the DEF injector clamp bolt.
  Torque : 5Nm
- Connect the electrical connector.
- Install the protective sleeve.
- Install the 2 modules to the 7 clips.
- Install the 4 wiring harness clips.
- Connect the 2 module electrical connectors.
- Install the right side undershield.
- Install and tighten the 23 bolts.
  Torque : 7Nm
- Install the cross member.
- Install and tighten the 4 bolts.
  Torque : 25Nm
Connect the startup battery ground cable.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT