LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2019 >> XF S >> Repair and Diagnosis >> External Pages >> Different car >> Section 230 (Exhaust System - INGENIUM I4 2.0L Diesel -- XE/(760)) >> Exhaust System - INGENIUM I4 2.0L Diesel (G1817300) >> Diagnosis And Testing >> Exhaust System DTC: Selective Catalytic Reduction (SCR) >> Symptom Chart

Symptom Chart

WARNING: This page is about a different car, the 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
SYMPTOM POSSIBLE CAUSES ACTION
Engine malfunction lamp illuminated
  • Selective catalyst reduction system failure
  • Diesel exhaust fluid level too low
  • Power or ground failure
  • Diesel exhaust fluid pressure too low
  • Diesel exhaust fluid pressure too high
  • Diesel exhaust fluid injection pump
  • Diesel exhaust fluid injector
  • Diesel exhaust fluid relay
  • Diesel exhaust fluid heater control unit
  • Pre selective catalytic reduction NOx sensor
  • Pre selective catalyst reduction NOx sensor module
  • Post selective catalyst reduction NOx sensor
  • Post selective catalyst reduction NOx sensor module
  • Post selective catalyst reduction particulate matter sensor
  • Post selective catalyst reduction particulate matter sensor module
  • Diesel sub net Controller Area Network (CAN) communication bus
  • Using the Jaguar Land Rover approved diagnostic equipment run the guided diagnostic flow by selecting customer concern area - 'Warnings'/'Messages'/'Diesel Exhaust Fluid'
  • Using the Jaguar Land Rover approved diagnostic equipment check the powertrain control module for related DTC  s and refer to relevant DTC  index
  • Check and correct the diesel exhaust fluid level
  • Refer to the electrical circuit diagrams and check connections are secure and wiring integrity
  • Refer to the repair information and the battery care information, inspect the vehicle battery and make sure it is fully charged and serviceable before performing further tests
  • Inspect connectors for signs of water ingress, and pins for damage and/or corrosion
  • Refer to the electrical circuit diagrams and check sensor, relays/fuses and control module power feeds and grounds
  • Check system for correct installation of components
  • Check system mechanical and fluid integrity
  • Check system for mechanical integrity
  • Check system for leakage
  • Check system for blockage
Engine will not crank
  • Vehicle battery failure
  • Diesel exhaust fluid level too low
  • Harness failure - Wiring integrity
  • Refer to the repair information and the battery care information, inspect the vehicle battery and make sure it is fully charged and serviceable before performing further tests
  • Inspect connectors for signs of water ingress, and pins for damage and/or corrosion
  • Check and correct the diesel exhaust fluid level
  • Using the Jaguar Land Rover Approved Diagnostic Equipment perform any required routines
Message warning
  • Selective catalyst reduction system failure
  • A monitor of the historical diesel exhaust fluid consumption rate, allied with a direct reading of the diesel exhaust fluid level in the tank, predicts that the distance to emptying the tank is less than 2400km
  • Using the Jaguar Land Rover Approved Diagnostic Equipment check the powertrain control module for related DTC  s and refer to relevant DTC  index
  • Check and correct the diesel exhaust fluid level