Exhaust Rear Section - Vehicles With 163 And 180 PS Engines

WARNING: This page is about a different car, the 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

The exhaust rear section has a single rear silencer.

The exhaust rear section is connected by a pipe to the exhaust center section and is secured with a clamp.

The exhaust rear section is supported with 2 hanger brackets. A hanger bracket forward and an other rearward of the rear silencer. Each is connected to a mounting rubber and bracket. A hanger bracket is welded on the side of the rear subframe, the other is bolted to the vehicle body.

The rear silencer has 2 mass dampers installed. A mass damper forward of the rear silencer secured to a bracket on the inlet pipe the other secured to a bracket attached to the rear silencer assembly.

The exhaust gases are expelled from the rear silencer via 1 outlet pipe. The outlet pipe is curved downwards to direct exhaust gases away from the rear of the vehicle.