LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2019 >> XF S >> Repair and Diagnosis >> External Pages >> Different car >> Section 211 (Electronic Engine Controls - INGENIUM I4 2.0L Diesel -- XE/(760)) >> Electronic Engine Controls - INGENIUM I4 2.0L Diesel (G1817213) >> Removal And Installation >> Exhaust Gas Pressure Sensor (G2454403) >> Installation

Exhaust Gas Pressure Sensor (G2454403): Installation

WARNING: This page is about a different car, the 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
    • Install the exhaust gas pressure sensor.
    • Tighten the exhaust gas pressure sensor nut.

      Torque  : 35Nm 

    • Install the bolt.

    Torque  : 10Nm 

    • Connect the exhaust gas pressure sensor electrical connector.
    • Install the clip.
  3. Install the catalytic converter.

    Refer to: CATALYTIC CONVERTER AND DIESEL PARTICULATE FILTER ASSEMBLY

  4. Connect the startup battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT

scientia non olet · About LEMON Manuals