LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2019 >> XF S >> Repair and Diagnosis >> External Pages >> Different car >> Section 183 (Supplemental Restraint System -- XE/(760)) >> Supplementary Restraint System (G1823241) >> Removal And Installation >> Restraints Control Module - Project 8 (G2248431) >> Installation

Restraints Control Module - Project 8 (G2248431): Installation

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
    • Install the Restraints Control Module (RCM).
    • Install and tighten the 3 nuts.

      Torque  : 11Nm 

    • Connect the 2 electrical connectors.
  2. Install the floor console.

    Refer to: the appropriate Floor Console information

  3. Connect the startup battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT

  4. If a new component has been installed, using the Jaguar Land Rover (JLR) approved diagnostic equipment to configure the RCM.

    General Equipment: Jaguar Land Rover approved diagnostic equipment 

scientia non olet · About LEMON Manuals