LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2019 >> XF S >> Repair and Diagnosis >> External Pages >> Different car >> Section 183 (Supplemental Restraint System -- XE/(760)) >> Supplementary Restraint System (G1823241) >> Removal And Installation >> Impact Pressure Sensor - Project 8 (G2250426) >> Installation

Impact Pressure Sensor - Project 8 (G2250426): Installation

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
    • Install the impact pressure sensor.
    • Install and tighten the 2 screws.

      Torque  : 1.9Nm 

    • Connect the electrical connector.
  2. Install the front door trim panel.

    Refer to: FRONT DOOR TRIM PANEL

  3. Connect the startup battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT

scientia non olet · About LEMON Manuals