LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2018 >> F-Pace Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 216 (Transfer Case - Vehicles With: 8HP70 8-Speed Automatic Transmission AWD/8HP45 8-Speed Automatic Transmission AWD/8HP45 8-Speed Automatic Transmission RWD -- XE (X760)) >> Transfer Case - Vehicles With: 8HP70 8-Speed Automatic Transmission AWD/8HP45 8-Speed Automatic Transmission AWD/8HP45 8-Speed Automatic Transmission RWD >> Transfer Case Draining And Filling (G1908027) >> General Procedures >> Filling

General Procedures: Filling

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
  1. NOTE: Make sure that all the component mating faces are clean.
    G11314254

    Install the new drain plug.

    Renew Part: Transfer case drain plug. 

    Torque Specification  : 25 Nm 

  2. G11314255

    Install the drain plug.

    Torque Specification  : 8 Nm 

  3. CAUTION: Make sure that the area around the component is clean and free of foreign material.
    NOTE: Do not discard the fill plug.
    G11314248

    Remove the fill plug.

  4. Fill transfer case with the recommended fluid, until the fluid is level with bottom of filler/level plug hole.

    Refer to: SPECIFICATIONS .

  5. NOTE: Make sure that all the component mating faces are clean.
    G11314248

    Install the fill plug.

    Torque Specification  : 8 Nm 

  6. CAUTION: Make sure that the area around the component is clean and free of foreign material.
    G11314247

    Remove the discard the fill plug.

  7. Fill transfer case with the recommended fluid, until the fluid is level with bottom of filler/level plug hole.

    Refer to: SPECIFICATIONS .

  8. CAUTION: Make sure that the area around the component is clean and free of foreign material.
    G11314247

    Install the new fill plug.

    Renew Part: Transfer case fill plug. 

    Torque Specification  : 25 Nm 

  9. G11314245
    1. Install the Noise, Vibration and Harshness damper bracket.
    1. Install the 3 bolts.

    Torque Specification  : 25 Nm 

  10. G11314251
    1. Install the NVH damper nuts.

      Torque Specification  : 45 Nm 

    1. Install the caps.
  11. Install the air deflector.

    Refer to: Air Deflector .

    • Drive the vehicle for approximately 1 Km (0.6 miles).
    • Connect an approved battery support unit/power supply to the vehicle.
    • Connect the approved Land Rover diagnostic equipment.
    • Check for Transfer Case Control Module (TCCM) software updates.
    • Update TCCM software if required.
    • With the engine running carry out diagnostic service function, "Transfer case - oil change reset  " procedure.
    • Disconnect the approved diagnostic equipment.
    • Disconnect the approved battery support unit/power supply from the vehicle.
scientia non olet · About LEMON Manuals