Transfer Case - Vehicles With: 8HP70 8-Speed Automatic Transmission AWD/8HP45 8-Speed Automatic Transmission AWD/8HP45 8-Speed Automatic Transmission RWD: Specifications
WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Make sure the correct transfer case fluid is used as specified. Use of any other fluids may result in a malfunction or failure.
LUBRICANTS
| ITEM | SPECIFICATION | CAPACITY (LITERS/US QUARTS) |
|---|---|---|
| Transfer case fluid | Statoil SL12-301 fill for life | 0.825/0.871 |
| Input shaft splines grease | Weicon anti-seize | - |
| Rear output flange spline locking fluid | Loctite 648 | 1 mm diameter bead |
TORQUE SPECIFICATIONS
| DESCRIPTION | NM | LB-FT |
|---|---|---|
| Transfer case mounting plate to transmission bolts | 43 | 32 |
| Transfer case to mounting plate bolts | 43 | 32 |
| Transfer case upper fluid drain plug | 8 | 6 |
| Transfer case upper fluid fill/level plug | 8 | 6 |
| Transfer case lower fluid drain plug | 25 | 18 |
| Transfer case lower fluid fill/level plug | 25 | 18 |
| Transfer Case Control Module bolts (TCCM) | 10 | 7 |
| Transfer Case actuator bolts | 10 | 7 |
| Transfer case mounting bush bolt | 110 | 81 |
| Transfer case crossmember bolts | 60 | 44 |
| Rear output flange nut (1) | 160 | 118 |
| Driveshaft to front output flange bolts (1) | - | - |
| Stage 1 | 40 | 30 |
| Stage 2 | 90 degrees | 90 degrees |
| Driveshaft to rear output flange bolts (1) | 75 | 55 |
| Damper mounting to transfer case bolts (2) | 25 | 18 |
| Damper to damper mounting nuts (2) | 45 | 33 |
| (1): New bolts/nuts must be installed. (2): If equipped. |
||