LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Body Closures) >> Body Closures >> Removal And Installation >> Liftgate >> Installation

Removal And Installation: Liftgate: Installation

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
  1. With assistance, install the liftgate.
    • Tighten the Torx bolts to 25 Nm (18 lb.ft).
    2. NOTE: Support the lifgate as necessary.
  2. Attach the liftgate support struts.
    • Secure with the clips.
  3. Attach the body harness to the liftgate.
    • Secure with the clips.
    • Connect the electrical connectors.
    • Secure the harness grommets into the liftgate.
  4. Disconnect the rear screen electrical connectors.
  5. Install the liftgate lower trim panel. Refer to Liftgate Lower Trim Panel information.
  6. Check and adjust the liftgate. Refer to Liftgate Alignment .
scientia non olet · About LEMON Manuals