Fuel Charging And Controls - GTDI 2.0L Petrol: Specifications

WARNING:

Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel related components. Highly flammable vapors are always present and may ignite. Failure to follow these instructions may result in personal injury.
Before any work is carried out on the fuel system, ground the vehicle to earth and maintain the ground connection until the work is complete.

CAUTION: Before disconnecting or removing components, make sure the area around the joint faces and connections are clean. Plug open connections to prevent contamination.

NOTE: Tighten the fuel rail high pressure fuel pump fuel line unions and fuel rail crossover pipe unions as it is instructed in the service information.

TORQUE SPECIFICATIONS

ITEM	NM	LB-FT	LB-IN
Throttle body retaining bolts	8	6	71
High pressure fuel pipe retaining bolt	10	7	-
High pressure fuel pipe unions
Stage 1	10	7	-
Stage 2	45°	45°	-
Fuel injection rail retaining bolts (1)
Initial torque	10	7.4	89
Stage 1	8	6	71
Stage 2	26°	26°	26°
Throttle body retaining bolts	8	6	71
High pressure fuel pump retaining bolts
Stage 1	5	4	44
Stage 2	55°	55°	55°
High pressure pump protective bracket fixings M6	11	8	97
High pressure pump protective bracket fixings M8	25	18	221
(1): Refer to the procedure for correct torque sequence, refer to fuel rail INSTALLATION .