LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2012 >> XKR 2D Coupe >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Body Closures -- XK/X150 >> Body Closures >> Liftgate >> Removal And Installation >> Installation

Removal And Installation: Installation

  1. With assistance, install the liftgate.
    • Tighten the Torx bolts to 25 Nm (18 lb.ft).
    2. NOTE: Support the lifgate as necessary.

  2. Attach the liftgate support struts.

    • Secure with the clips.
  3. Attach the body harness to the liftgate.
    • Secure with the clips.
    • Connect the electrical connectors.
    • Secure the harness grommets into the liftgate.
  4. Disconnect the rear screen electrical connectors.
  5. Install the liftgate lower trim panel.

    For additional information, refer to: Liftgate Lower Trim Panel

  6. Check and adjust the liftgate.

    For additional information, refer to: Liftgate Alignment 

scientia non olet · About LEMON Manuals