Pinpoint Test D: Twist In Webbing

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.

D1: TWIST IN WEBBING
1. Refer to the removal and installation service information, remove any trim panels required to expose the D loop (anchor point). Go to: FRONT SAFETY BELT RETRACTOR (REMOVAL AND INSTALLATION), or REAR SAFETY BELT RETRACTOR - 2-DOOR (G539373) , or REAR SAFETY BELT RETRACTOR - CONVERTIBLE (G563185) .
2. Twist the webbing back the correct way in the loop
3. Pass the twist through the pillar loop or escutcheon as required
4. Check for correct operation twice
Does the webbing move freely then retract correctly?
- Yes
  Refer to: FRONT SAFETY BELT RETRACTOR (REMOVAL AND INSTALLATION), or REAR SAFETY BELT RETRACTOR - 2-DOOR (G539373) , or REAR SAFETY BELT RETRACTOR - CONVERTIBLE (G563185) , reinstall any trim panels, ensure there are no obstructions and the webbing does not catch or rub. No further action required.
- No
  GO to PINPOINT TEST E .