Pinpoint Test E: Interference-Webbing Routing
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
- E1: INTERFERENCE-WEBBING ROUTING
- Remove any trim panels required to expose the D loop (anchor point). Go to: FRONT SAFETY BELT RETRACTOR (REMOVAL AND INSTALLATION), or REAR SAFETY BELT RETRACTOR - 2-DOOR (G539373) , or REAR SAFETY BELT RETRACTOR - CONVERTIBLE (G563185) .
- Remove obstructions and foreign objects ensure the webbing does not catch or rub
- Confirm the seatbelt does not contact the wiring harness
- Check for correct operation twice
Does the webbing move freely then retract correctly?
- Yes
Reinstall any trim panels, ensure there are no obstructions and the webbing does not catch or rub. No further action required. Go to: FRONT SAFETY BELT RETRACTOR (REMOVAL AND INSTALLATION), or REAR SAFETY BELT RETRACTOR - 2-DOOR (G539373) , or REAR SAFETY BELT RETRACTOR - CONVERTIBLE (G563185) .
- No
GO to PINPOINT TEST F .