Pinpoint Test C: SEATBELT Retractor-Webbing Guide Loose

1. Refer to the removal and installation service information, remove any trim panels required to expose the D loop (anchor point) and seatbelt retractor. Go to: FRONT SAFETY BELT RETRACTOR  (REMOVAL AND INSTALLATION), or REAR SAFETY BELT RETRACTOR - 2-DOOR (G539373) , or REAR SAFETY BELT RETRACTOR - CONVERTIBLE (G563185) .
2. Check the webbing is not trapped or twisted and is centrally located on the seatbelt retractor spindle
3. Attempt to withdraw the webbing from the seatbelt retractor
   NOTE: If the seatbelt webbing is jammed, the automatic locking retractor could be engaged
4. To release the automatic locking retractor, manually wind the webbing onto the spindle until the automatic locking retractor deactivates (clicking stops)
5. Fully extract webbing
6. Confirm webbing guide location is correct, Confirm the fixing lugs are correctly located in the retractor frame
7. Allow webbing to retract
8. Check for correct operation twice 

Does the webbing move freely then retract correctly?

• Yes 

  Refer to the removal and installation service information, reinstall any trim panels, ensure there are no obstructions and the webbing does not catch or rub. No further action required. Go to: FRONT SAFETY BELT RETRACTOR (REMOVAL AND INSTALLATION), or REAR SAFETY BELT RETRACTOR - 2-DOOR (G539373) , or REAR SAFETY BELT RETRACTOR - CONVERTIBLE (G563185) .

• No 

  GO to PINPOINT TEST D .