LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Battery, Mounting & Cables -- XK/X150) >> Battery, Mounting And Cables >> Battery Disconnect And Connect (G1075549) >> General Procedures >> Connecting

General Procedures: Connecting

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
  1. NOTE: Make sure that both the positive and negative battery terminals are correctly located when installed.
    G11516159

    To install, reverse the removal procedure.

    Torque Specification: 6 Nm 

  2. NOTE: This step is only necessary when installing a new battery.

    Using Jaguar approved diagnostic equipment, reset the battery monitoring system (BMS).

  3. Door Window Motor Initialization

    Refer to: Door Window Motor Initialization (Glass, Frames and Mechanisms, General Procedures).

  4. Enter the audio unit preset radio frequencies.
  5. Reset the clock to the correct time.
  6. Start the engine and allow to idle until the engine reaches normal operating temperature.
  7. Switch the engine off.
scientia non olet · About LEMON Manuals