LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2011 >> XK 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 63 (Glass, Frames & Mechanisms -- XK/X150) >> Glass, Frames And Mechanisms >> Door Window Motor Initialization >> General Procedures

General Procedures

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2015 Jaguar XK, 2014 Jaguar XKR-S, and 2014 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
  1. NOTE: After the battery has been disconnected it is necessary to initialize each door window motor separately to operate the "one-touch" up function.

    Operate the window control switch until the door window glass is in the fully closed position, continue to operate the window control switch for a further two seconds.

  2. Release the window control switch.
  3. Operate the window control switch in the closed position and continue to operate the window control switch for a further two seconds.
  4. Operate the window control switch until the door window glass is in the fully open position ("one-touch" down).
  5. NOTE:
    • If the door window motor initialization has been completed correctly, when the window control switch is operated, the door window glass should move to the fully closed position ("one-touch" up) automatically.
    • If the door window glass does not fully close automatically ("one-touch" up), repeat the complete procedure.

    Operate the window control switch once to the close position.

  6. Repeat the door window motor initialization for each door window motor.
scientia non olet · About LEMON Manuals