Floor Console: Installation
- Install and connect center console.
- Position console for access.
- Connect valet switch and cigar lighter harness multiplugs.
- Finally position console.
- Fit and tighten forward securing bolts.
- Fit and tighten rear securing bolts.
- Fit and fully seat console rear trim cover.
- Position veneer panel for access and connect panel switch harness multiplugs.
- Reposition and seat veneer panel.
- Align and fit panel mounting brackets.
- Fit and tighten panel securing screws.
- Fit 'J' gate surround. Refer to SELECTOR LEVER GATE FINISH PANEL .
- Connect ground cable to battery terminal and fit battery cover. Refer to BATTERY RECONNECTION PROCEDURE .