Battery Reconnection Procedure
WARNING:
BATTERIES PRODUCE EXPLOSIVE GASES WHICH MAY CAUSE PERSONAL INJURY. DO NOT EXPOSE THE BATTERY TO A NAKED FLAME. WHEN CHARGING OR WORKING NEAR A BATTERY WEAR PROTECTIVE CLOTHING AND EYE PROTECTORS. ALWAYS PROVIDE ADEQUATE VENTILATION. FAILURE TO FOLLOW THESE INSTRUCTIONS MAY RESULT IN PERSONAL INJURY.
WARNING:
BATTERIES CONTAIN SULFURIC ACID, AVOID CONTACT WITH SKIN, EYES AND CLOTHING. SHIELD YOUR EYES WHEN WORKING NEAR THE BATTERY TO PROTECT AGAINST POSSIBLE CONTACT OF THE ACID SOLUTION. IN CASE OF CONTACT WITH THE SKIN OR EYES, FLUSH IMMEDIATELY FOR A MINIMUM OF 15 MINUTES AND SEEK PROMPT MEDICAL ATTENTION. IF SWALLOWED CALL A PHYSICIAN IMMEDIATELY. FAILURE TO FOLLOW THESE INSTRUCTIONS MAY RESULT IN PERSONAL INJURY.
CAUTION:
Make sure all electrical systems are off before connecting the battery negative cable. Failure to follow these instructions may result in damage to the electrical system.
NOTE:
Whether one, or both, cables are disconnected, a minimum of 30 seconds MUST elapse between disconnection of the FIRST cable and reconnection of the LAST cable. A clean final connection must be made; do not allow temporary contact.
- Connect the battery terminal(s).
- Reset the clock.
- Enter the radio security code. If necessary, refer to the Sound System Handbook.
- Cycle (both) door drop glass up and down to establish the upper and lower datum points.
- Switch the ignition ON.
- Lower the glass to the stop and hold the switch in the DOWN position for a further five seconds.
- Raise the glass fully and hold the switch in the UP position for a further five seconds.
- Switch the ignition off.