LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Torque Converter Clutch/Cruise Control Release Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Cruise Release Switch
    GM1302096Courtesy of GENERAL MOTORS CORP.
  1. Slide only the torque converter clutch/cruise control release switch retainer into the brake pedal bracket, until the locking tabs are fully engaged.
  2. Connect the electrical connector to the torque converter clutch/cruise control release switch.
  3. Adjust the torque converter clutch/cruise control release switch. Refer to Torque Converter Clutch/Cruise Control Release Switch Adjustment .
scientia non olet · About LEMON Manuals