LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Torque Converter Clutch/Cruise Control Release Switch Adjustment

Torque Converter Clutch/Cruise Control Release Switch Adjustment

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Cruise Release Switch
    GM1302096Courtesy of GENERAL MOTORS CORP.
  1. Rotate the torque converter clutch/cruise control release switch counter clockwise, allowing the retainer to release.
  2. Pull the brake pedal rearward to full stop.
  3. While holding the brake pedal in position rearward, push the switch inward fully until the switch body contacts the brake pedal arm.

    At this point the plunger in the switch should be pushed in.

  4. Rotate the switch clockwise until a "click" is heard.
scientia non olet · About LEMON Manuals