3-4 Clutch Plate Travel Check
WARNING: This page is about a different variant/trim than selected.
- Use feeler gauges to check the 3rd and 4th clutch plate travel.
- Check the travel between the selective backing plate (655) and the first fiber plate assembly (654A).
The 3rd and 4th clutch plate travel should be:
Specification:
- Five plate - 0.99-2.14 mm (0.038-0.084 in)
- Six plate - 0.90-2.10 mm (0.035-0.082 in)
- Seven plate - 1.12-2.04 mm (0.044-0.080 in)
- Select the proper 3rd and 4th clutch selective backing plate to obtain the correct travel. Refer to Third and Fourth Clutch Backing Plate Selection .