LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 85 (Transfer Case - ISUZU T150) >> Diagnostic Information and Procedures >> Service Four-Wheel Drive Indicator Inoperative >> Test Description

Test Description

WARNING: This page is about a different car, the 2007 Isuzu i-370, 2007 GMC Canyon, and 2007 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.

The number below refers to the step number on the diagnostic table.

  1. 2:  This step determines if there is a class 2 communication error or if the IPC is faulty.
Service Four-Wheel Drive Indicator Inoperative

Step Action Yes No
Schematic Reference:  Transfer Case Control Schematics  
Connector End View Reference:  Transfer Case Control Connector End Views  
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle
Does any module set a DTC beginning with a 'U'? Go to Scan Tool Does Not Communicate with Class 2 Device Go to Step 3 
3 Replace the instrument panel cluster. Refer to Instrument Cluster Replacement .
Did you complete the repair?
Go to Step 4  -
4
  1. Use the scan tool in order to clear the DTCs.
  2. Operate the vehicle to determine if the symptom has been corrected.
Is the symptom still present?
Go to Step 1  System OK