LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 78 (Engine Mechanical - 4.6L - 2 Of 4) >> On-Vehicle Repair Instructions (2 Of 2) >> Oil Pan Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Engine Harness Electrical Connectors
    GM1663951Courtesy of GENERAL MOTORS CORP.
  1. Drain the engine oil. Refer to Engine Oil and Oil Filter Replacement .
  2. Remove the front exhaust manifold pipe. Refer to Exhaust Manifold Pipe Replacement - Front .
  3. Disconnect the engine harness electrical connector (2) from the oil level sensor.
    4. Fig 2: View Of Oil Pan
    GM1663953Courtesy of GENERAL MOTORS CORP.
  4. Loosen the oil pan bolts (1).
  5. Remove the oil pan (2) and discard the oil pan gasket.
  6. Clean and inspect the oil pan, if necessary. Refer to Oil Pan Cleaning and Inspection .
scientia non olet · About LEMON Manuals