LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 66 (Engine Cooling System) >> Repair Instructions >> Draining and Filling Cooling System (Static Fill) >> Filling Procedure

Filling Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The procedure below must be followed. Improper coolant level could result in a low or high coolant level condition, causing engine damage.
  1. Install the lower radiator hose.
  2. Using the J 38185  reposition the lower radiator hose clamp to the radiator. See Special Tools .
  3. Lower the vehicle.
  4. Slowly add a mixture of 50/50 DEX-COOL antifreeze and deionized water to the cooling system through the top of the surge tank opening. Refer to Capacities - Approximate Fluid .
  5. Fill the surge tank to the FULL COLD level.
  6. Install the surge tank cap.
  7. Idle the engine for 2 minutes and occasionally raise the throttle to 3,000-3,500 RPM.
  8. Turn off the engine and allow the engine to cool.
  9. Repeat the steps 3-7.
  10. Install the air deflector. Refer to Front Air Deflector Replacement .
  11. Install the air box. Refer to Air Cleaner Assembly Replacement .
  12. Allow the engine to cool.
  13. Remove the surge tank cap and fill to the FULL COLD level.
  14. Use the J 26568  to inspect the concentration of the engine coolant. See Special Tools .
  15. Rinse away any excess coolant from the engine and the engine compartment.
scientia non olet · About LEMON Manuals