Center Pillar Upper Garnish Molding Replacement

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Center Pillar Upper Garnish Molding Replacement

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
NOTE: Refer to Fastener Notice . Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .
1	Cover, Upper Garnish Molding
2	Screw, Upper Garnish Molding Tighten: 2 N.m (18 lb ft)
3	Panel Assembly, Center Pillar Upper Trim Tip: Remove the seat belt D-ring from the adjuster assembly. Pull the trim panel toward the inside of the vehicle to disengage the retainers. Tighten: 35 N.m (25 lb ft)