LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (Parking Brake System) >> Repair Instructions >> Parking Brake Actuator Replacement (J55) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release the park brake.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
    Fig 1: Identifying Park Brake Cable Components
    GM106224Courtesy of GENERAL MOTORS CORP.
  4. Pull down on the park brake cable near the park brake connector (1).
  5. Disconnect the left rear park brake cable (2) from the rear equalizer (1).
  6. Disconnect the right rear park brake cable (5) from the intermediate park brake cable (3).
  7. Remove the rear park brake cable from the park brake actuator lever.
  8. Remove the rotor. Refer to Rear Brake Rotor Replacement (J55) or Rear Brake Rotor Replacement (JL9) .
  9. Remove the park brake shoe. Refer to Park Brake Shoe Replacement .
  10. Remove the actuator lever from the backing plate.
scientia non olet · About LEMON Manuals