LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 44 (Hydraulic Brake System) >> Repair Instructions >> Master Cylinder Reservoir Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the master cylinder from the vehicle. Refer to Master Cylinder Replacement .
  2. Disconnect the electrical connector from the fluid level sensor.
  3. Remove the master cylinder fluid level sensor. Refer to Master Cylinder Fluid Level Sensor Replacement .
  4. Drain the brake fluid from the master cylinder reservoir.
    5. Fig 1: Removing/Installing Reservoir Retaining Pins
    GM176838Courtesy of GENERAL MOTORS CORP.
  5. Carefully tap back the retaining pins until clear of master cylinder reservoir.
    6. Fig 2: Installing Reservoir Onto Master Cylinder
    GM153127Courtesy of GENERAL MOTORS CORP.
  6. Remove the master cylinder reservoir from the master cylinder.
  7. Remove the seals from the master cylinder reservoir.
scientia non olet · About LEMON Manuals