Master Cylinder Replacement

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Master Cylinder Replacement

GM1574969

Courtesy of GENERAL MOTORS CORP.

Master Cylinder Replacement

Callout	Component Name
CAUTION: Remove all the air from the hydraulic brake system anytime the hydraulic brake system is opened for repair. The entire bleeding procedure must be followed. Failure to remove all the air in the hydraulic brake system will result in reduced braking performance and possible personal injury. CAUTION: Refer to Brake Fluid Irritant Caution . NOTE: Refer to Brake Fluid Effects on Paint and Electrical Components Notice . NOTE: Refer to Fastener Notice . Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .
1	Nut, Brake Pipe (Qty: 2) Tip: Cap or plug the brake pipes to prevent fluid loss and contamination. Bleed the brake system anytime the system is opened for repairs. Refer to Hydraulic Brake System Bleeding (Manual) or Hydraulic Brake System Bleeding (Pressure) . Tighten: 29 N.m (21 lb ft)
2	Nut, Master Cylinder (Qty: 2) Tighten: 30 N.m (22 lb ft)
3	Cylinder, Brake Master Tip: Remove electrical connector from the brake master cylinder switch. Bench bleed the master cylinder. Refer to Master Cylinder Bench Bleeding .