Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Accumulator Components

Courtesy of GENERAL MOTORS CORP.

Lubricate all seals and metal friction points with power steering fluid.
Install the accumulator (2) and O-ring seal (3).

Fig 2: View Of Accumulator & C-Clamp

Courtesy of GENERAL MOTORS CORP.

Place the J 26889 over the end of the accumulator. See Special Tools .
Install the nut on the stud.
Press the accumulator with a C-clamp.

Fig 3: Identifying Brake Booster Retaining Ring & Access Hole

Courtesy of GENERAL MOTORS CORP.

Install the accumulator retainer ring (1).

Fig 4: View Of Accumulator & C-Clamp

Courtesy of GENERAL MOTORS CORP.

Release the C-clamp.
Remove the nut from the stud.
Remove the J 26889 . See Special Tools .

Fig 5: View Of Master Cylinder & Hydraulic Brake Booster

Courtesy of GENERAL MOTORS CORP.

Install the master cylinder to the hydraulic booster. Refer to Master Cylinder Replacement .