Repair Procedures
WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Perform the Brake Pedal Position Sensor Calibration after replacement of the brake pedal position sensor.
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
- Brake Pedal Position Sensor Replacement
- Tail Lamp Replacement
- Tail Lamp Replacement
- Relay Replacement (Attached to Wire Harness) or Relay Replacement (Within an Electrical Center)
- Control Module References for BCM replacement, setup, and programming