LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 37 (Horn System) >> Repair Instructions >> Horn Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Horns Fastener
    GM545724Courtesy of GENERAL MOTORS CORP.
    NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  1. Install the horns to the body.
  2. Install the fastener in order to secure the horns to the body.

    Tighten:  Tighten the bolts to 15 N.m (11 lb ft).

    3. Fig 2: View Of Horn & Connectors
    GM545772Courtesy of GENERAL MOTORS CORP.
  3. Connect the horn connectors (1) to the horns.
  4. Install the front air deflector. Refer to Front Air Deflector Replacement .
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals