LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 36 (Wiper System & Washer System) >> Repair Instructions >> Air Inlet Grille Panel Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the washer hose and the washer hose grommet through the hole in the plenum area.
  2. Press the washer hose grommet into position and ensure that it is fully seated.
    3. Fig 1: View Of Air Inlet Grill Panels & Push In Retainers
    GM457411Courtesy of GENERAL MOTORS CORP.
  3. Install the air inlet grille panels (1) to the vehicle.
  4. Connect the washer hose connector.
  5. Install the push in retainers (2) in order to secure the air inlet grille panel (1) to the body.
  6. Install the windshield wiper arms. Refer to Wiper Arm Replacement .
  7. Close the hood.
scientia non olet · About LEMON Manuals