LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Rear Suspension System) >> Repair Instructions >> Wheel Bearing/Hub Replacement - Rear (FE1, FE3) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  3. Remove the brake rotor. Refer to Rear Brake Rotor Replacement (J55) or Rear Brake Rotor Replacement (JL9) .
    4. Fig 1: View Of ABS Sensor Wire Connector
    GM293367Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the ABS sensor wire connector.
    5. Fig 2: View of Wheel Bearing, Hub, & Dust Shield
    GM105034Courtesy of GENERAL MOTORS CORP.
  5. Remove the wheel bearing/hub bolts.
  6. Remove the wheel bearing/hub and brake shield.
scientia non olet · About LEMON Manuals