LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Rear Suspension System) >> Repair Instructions >> Rear Axle Lower Control Arm Replacement (FE7) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear suspension support assembly. Refer to Support Replacement - Rear (W/FE1, FE3) or Support Replacement - Rear (W/FE7) .
    2. Fig 1: View Of Stabilizer Shaft Link Insulators, Spacer, Nut & Bolt
    GM561499Courtesy of GENERAL MOTORS CORP.
  2. Remove the stabilizer link bolt.
  3. Remove the hub and bearing, if necessary. Refer to Wheel Bearing/Hub Replacement - Rear (FE1, FE3)  or Wheel Bearing/Hub Replacement - Rear (FE7) .
    4. Fig 2: View Of Center Support Brackets
    GM475482Courtesy of GENERAL MOTORS CORP.
  4. Remove the support bracket bolts (1).
    5. Fig 3: View Of Control Arm, Nuts & Bolts (FE7)
    GM474758Courtesy of GENERAL MOTORS CORP.
  5. Remove the nuts and bolts securing the control arm to the rear suspension support assembly.
  6. Remove the control arm.
scientia non olet · About LEMON Manuals