LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Engine Control System & Fuel System - 4.6L - Introduction (2 Of 2)) >> Repair Instructions >> Secondary Air Injection Pump Inlet Hose/Duct Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Secondary AIR Pump Inlet Tube/Hose
    GM1665331Courtesy of GENERAL MOTORS CORP.
  1. Remove the front air deflector. Refer to Front Air Deflector Replacement .
  2. Disconnect the secondary air injection (AIR) pump inlet hose quick connect fitting from the AIR pump. Refer to Plastic Collar Quick Connect Fitting Service .
  3. Lower the vehicle.
  4. Disconnect the AIR pump inlet hose quick connect fitting from the air cleaner. Refer to Plastic Collar Quick Connect Fitting Service .
  5. Remove the AIR pump inlet hose from the vehicle.